Skip to content

Questions for the expert

Total questions: 48. Find suitable wording and compile a selection for discussing the brief.

Search questionsExamination topic

Examination of lifts and lifting equipment

Which reported faults are supported by the materials and inspection?
Do the replacement components comply with the equipment documentation?
Which installation defects can be established?
Is the work performed consistent with the repair records?
Which further checks are needed to establish the cause of shutdowns?

Ventilation and air conditioning examination

Does the actual configuration comply with the design solutions?
What are the operating parameters under the conditions examined?
Are there signs of installation or commissioning defects?
How do changes to rooms affect system operation?
Which identified defects relate to the reported complaints?

Examination of heating and heat supply systems

Does the installed equipment comply with the design?
Which temperature parameters were recorded during the inspection?
Are there accessible signs of installation defects?
Can the configuration identified explain uneven heating?
What work is needed to remedy the established defects?

Water supply and drainage examination

Where is the identifiable source of the leak located?
Which defects are present in connections and pipes?
Does the installation comply with the solutions provided?
Which signs relate to the cause of blockage or impaired drainage?
Which data are missing for distinguishing possible causes?

Technical examination of gas systems

What discrepancies exist between the installation and documentation?
Which defects recorded in the reports are confirmed by inspection?
Do the products used comply with the requirements provided?
Are the materials sufficient to explain the reported fault?
Which questions require special tests by an authorised contractor?

Examination of pumps and engineering equipment

Is the unit suitable for the agreed application conditions?
Which defects can be established?
Are there signs of incorrect installation or maintenance?
Are the recorded operating conditions consistent with the manufacturer's documentation?
Which possible causes of failure are supported by the submitted data?

Installation quality and quantities of engineering work

What work has actually been completed in the accessible part?
Do the materials and equipment comply with the agreed specification?
Which installation defects have been established?
Are there documented discrepancies in quantities?
What work is needed to remedy the identified defects?

Review of an engineering expert report

Do the methods correspond to the questions posed?
Are measurement conditions and the system's operating mode described?
Can the calculations and input values be checked?
Have significant alternative causes been considered?
Do the conclusions follow from the results actually obtained?

Additional questions for the reviewer

Are the system access and inspection conditions stated?
Was the operating mode recorded during measurements?
Are the calculation input values supported?
Are the measuring instruments suitable for the parameters checked?
Are design, installation and operational causes distinguished?
Were system changes after the incident considered?
Are the consequences of inaccessible concealed sections explained?
Is every conclusion justified by examination findings?